Dell 9.7(0.0) manual Ip redirect-group redirect-list-name

	Version	Description
	7.7.1.0	Introduced on the E-Series ExaScale.
Related	ip redirect-list – enables an IP Redirect List.
Commands

ip redirect-group

Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this command multiple times.

S6000

Syntax ip redirect-group redirect-list-name

Parameters

Defaults

Command Modes

Command History

Usage Information

To remove a redirect list from an interface, use the no ip redirect-groupname command.

redirect-list-	Enter the name of a configured redirect list.
name

none

INTERFACE (conf-if-vl-)

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.4(0.0)	Introduced on the S4810, S4820T, S6000, and Z9000.

8.4.2.1Introduced on the C-Series and S-Series.

8.4.2.0Introduced on the E-Series Tera Scale.

7.7.1.0Introduced on the E-Series ExaScale.

You can apply any number of redirect-groups to an interface. A redirect list can contain any number of configured rules. These rules includes the next-hop IP address where the incoming traffic is to be redirected.

If the next hop address is reachable, traffic is forwarded to the specified next hop. Otherwise, the normal routing table is used to forward traffic. When a redirect- group is applied to an interface and the next-hop is reachable, the rules are added into the PBR CAM region. When incoming traffic hits an entry in the CAM, the traffic is redirected to the corresponding next-hop IP address specified in the rule.

NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.

Policy-based Routing (PBR) 1177