Dell 9.7(0.0) manual Debug ip bgp updates, Usage

Usage	This command turns on BGP soft-reconfiguration inbound debugging. If no
Information	neighbor is specified, debug turns on for all neighbors.

debug ip bgp updates

Allows you to view information about BGP updates.

S6000

Syntaxdebug ip bgp [vrf vrf-name] [A.B.C.D X:X:X:X::X peer-group peer-group-name] updates [in out prefix-list prefix-list- name]

To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D X:X:X:X::X peer-grouppeer-group-name] updates [in out prefix-listprefix-list-name]command.

Parameters

Command Modes

Command History

vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of
	the VRF to view BGP updates information corresponding to
	that VRF.
A.B.C.D	(OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X	(OPTIONAL) Enter an IPv6 address.
peer-group	(OPTIONAL) Enter the keyword peer-groupfollowed by the
peer-group-	name of the peer group.
name
in	(OPTIONAL) Enter the keyword in to view only BGP updates
	received from neighbors.
out	(OPTIONAL) Enter the keyword out to view only BGP
	updates sent to neighbors.
prefix-list	(OPTIONAL) Enter the keyword prefix-listthen the
prefix-list-	name of an established prefix list. If the prefix list is not
name	configured, the default is permit (to allow all routes).
ip-address	(OPTIONAL) Enter the IP address of the neighbor in dotted
	decimal format.
peer-group-	(OPTIONAL) Enter the name of the peer group to disable or
name	enable all routers within the peer group.
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Border Gateway Protocol 375