VersionDescription

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

Usage

This command applies to dynamic port-channel interfaces only. When applied on a

Information

static port-channel, this command has no effect.

Related

show lacp — displays the LACP configuration.

Commands

 

lacp port-priority

To influence which ports will be put in Standby mode when there is a hardware limitation that prevents all compatible ports from aggregating, configure the port priority.

S6000

Syntax

lacp port-priority priority-value

Parameters

Defaults

Command Modes

Command History

To return to the default setting, use the no lacp port-prioritypriority- value command.

priority-valueEnter the port-priority value. The higher the value number, the lower the priority. The range is from 1 to 65535. The default is 32768.

32768

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

Link Aggregation Control Protocol (LACP)

913

Page 913
Image 913
Dell 9.7(0.0) manual Lacp port-priority priority-value