Dell 9.7(0.0) manual Redundancy protocol, Reset stack-unit, Hard

redundancy protocol

Enable hitless failover for a protocol.

Syntax

Protocols

Defaults

Command Modes

Command History

redundancy protocol

lacp	Enter the LACP protocol
xstp	Enter one of the following protocols: STP, RSTP, MSTP,
	PVST.
Not enabled.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.7.0Introduced on the S4810.

8.3.11.1Introduced on the Z9000.

8.3.1.0Added the members option.

reset stack-unit

Reset any designated stack member except the management unit (master unit).

Syntax

Parameters

Defaults

Command Modes

Command History

reset stack-unit <0–5> hard

stack-unit	Enter the stack-unit number. For the S6000, the range is
	from 0 to 5.
hard	Reset the stack unit if the unit is in a problem state.
none
EXEC

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

1532 Stacking