debug ip icmp

View information on the internal control message protocol (ICMP).

S6000

Syntax

debug ip icmp [interface] [count value]

 

To disable debugging, use the no debug ip icmp command.

Parameters

interface

(OPTIONAL) Enter the following keywords and slot/port or

 

number information:

Command Modes

Command History

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

• For the Management interface on the stack-unit, enter

 

the keyword ManagementEthernet then the slot/port

 

information. The slot range is from 0 to 1. The port range

 

is 0.

 

• For a port channel interface, enter the keywords port-

 

channel then a number. The range is from 1 to 128.

 

• For a VLAN interface, enter the keyword vlan then a

 

number from 1 to 4094.

count value

(OPTIONAL) Enter the keyword count then the count value.

 

The range is from 1 to 65534. The default is Infinity.

EXEC Privilege

 

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.3.7.0Introduced on the S4810.

8.2.1.0Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was 2094).

756

IPv4 Routing

Page 756
Image 756
Dell 9.7(0.0) manual Debug ip icmp interface count value