Dell 9.7(0.0) manual Ip pim sparse-mode sg-expiry-timer

VersionDescription

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.8.1.0Introduced on the C-Series for the port-channels and the S- Series.

Usage	The interface must be enabled (the no shutdown command) and not have the
Information	switchport command configured. Multicast must also be enabled globally (using
	the ip multicast-lag-hashingcommand). PIM is supported on the port-
	channel interface.

ip pim sparse-mode sg-expiry-timer

Enable expiry timers globally for all sources.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

ip pim [vrf vrf-name] sparse-mode sg-expiry-timer seconds

To disable configured timers and return to default mode, use the no ip pim [vrf vrf-name]sparse-modesg-expiry-timercommand.

vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of
	the VRF to enable expiry timer for all sources on that VRF.
	NOTE: Applies to specific VRF if input is provided, else
	applies to Default VRF.
seconds	Enter the number of seconds the S, G entries are retained.
	The range is from 211 to 65535.

Disabled. The default expiry timer (with no times configured) is 210 sec.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

1200 PIM-Sparse Mode (PIM-SM)