Usage Information

Related Commands

VersionDescription

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

pre- 6.2.1.1

Introduced on the E-Series.

When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are possible.

To ensure that only specific interfaces are receiving and sending data, use the passive-interfacecommand with the neighbor command.

passive-interface — sets the interface to only listen to RIP broadcasts.

network

Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this command.

S6000

Syntax

network ip-address

 

To disable RIP for a network, use the no network ip-addresscommand.

Parameters

ip-address

Specify an IP network address in dotted decimal format. You

 

cannot specify a subnet.

Defaults

Command Modes

Command History

No RIP network is configured.

ROUTER RIP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

Routing Information Protocol (RIP)

1315

Page 1315
Image 1315
Dell 9.7(0.0) manual Network, Usage Information Related Commands VersionDescription