Command Modes

Command History

Usage Information

Example

•For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

•For a port channel interface, enter the keywords port- channel then a number. The range is from 1 to 128.

•For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.2.(0.0)

Introduced on the S4820T, S4810, and Z9000.

The following section describes the command fields.

Lines Beginning

Description

With or Including

 

OSPFv3...

Debugging is on for all OSPFv3 packets and all interfaces.

05:21:01

Displays the time stamp.

Sending Ver:3

Sending OSPF3 version..

Dell(conf-if-te-1/2)#do debug ipv6 ospf bfd te 1/2

OSPFv3 bfd related debugging is on for TenGigabitEthernet 1/2

00:59:26 : OSPFv3INFO: Received Interface mode bfd config

command on interface Te 1/2 Enable 1, interval 0, min_rx 0,

Multiplier 0, role 0, Disable 0

00:59:26 : OSPFv3INFO: Enabling BFD on interface Te 1/2 Cmd Add Session

00:59:27 : OSPFv3INFO: Enabling BFD for NBRIP fe80:0000:0000:0000:0201:e8ff:fe8b:7720

00:59:27 : OSPFv3INFO: Completed Enabling BFD on interface Te 1/2

00:59:27 : OSPFv3INFO: Completed Interface mode BFD configuration on Te 1/2!!

00:59:27 : OSPFv3INFO: Enabling BFD for NBRIP fe80:0000:0000:0000:0201:e8ff:fe8b:7720

00:59:27 : OSPFv3INFO: Ospf3_register_bfd ospf key 27648

00:59:27 : OSPFv3INFO: OSPFV3 Enabling BFD for NBRIP fe80:0000:0000:0000:0201:e8ff:fe8b:7720 Interface Te 1/2 IfIndex 34145282

00:59:27 : OSPFv3INFO: BFD parameters interval 100 min_rx 100 mult 3 role active

00:59:27 : OSPFv3INFO: BFD parameters interval 100 min_rx 100 mult 3 role active

00:59:27 : OSPFv3INFO: Completed Enabling BFD for NBRIP fe80:0000:0000:0000:0201:e8ff:fe8b:7720

Aug 25 11:19:59: %STKUNIT0-M:CP %BFDMGR-1-BFD_STATE_CHANGE: Changed session state to Init for neighbor fe80::201:e8ff:fe8b: 7720 on interface Te 1/2 (diag: NBR_DN)

Aug 25 11:20:00: %STKUNIT0-M:CP %BFDMGR-1-BFD_STATE_CHANGE:

Open Shortest Path First (OSPFv2 and OSPFv3)

1147

Page 1147
Image 1147
Dell 9.7(0.0) manual Dellconf-if-te-1/2#do debug ipv6 ospf bfd te 1/2, OSPFv3INFO Received Interface mode bfd config