Dell 9.7(0.0) manual Control and Monitoring, Banner exec c line c, Line

4

Control and Monitoring

This chapter contains the commands to configure and monitor the system, including Telnet, file transfer protocol (FTP), and trivial file transfer protocol (TFTP).

NOTE: Starting in version 9.0.2.0, the enable xfp-power-updatescommand was deprecated for the S6000 This command replaces the enable optic-info-update interval command to update information on temperature and power monitoring in the simple network management protocol (SNMP) management information base (MIB).

banner exec

Configure a message that is displayed when your enter EXEC mode.

Syntax

Parameters

Defaults

Command Modes

Command History

banner exec c line c

To delete a banner, use the no banner exec command.

c	Enter the keywords banner exec, then enter a character
	delineator, represented here by the letter c. Press ENTER.
line	Enter a text string for your banner message ending the
	message with your delineator. In the following example, the
	delineator is a percent character (%); the banner message is
	“testing, testing”.

No banner is displayed.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

Control and Monitoring 89