Dell 9.7(0.0) manual Ip vlan-flooding, Defaults Command Modes Command History Example Multicast

Defaults

Command Modes

Command History

Example (Multicast)

output-range	For a multicast MAC address, enter the keyword output-
interface	range then one of the following interfaces to indicate a
	range of ports for which traffic is forwarded:
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
	• For a port channel interface, enter the keywords port-
	channel then a number.
vlan vlan-id	Enter the keyword vlan then a VLAN ID number from 1 to
	4094.
Not configured.
CONFIGURATION

The following is a list of the Dell Networking OS version history for this command.

Version 9.3(0.0) Added support for multicast MAC address on the MXL platform.

mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range Te 1/2,Te 1/3}

ip vlan-flooding

Enable unicast data traffic flooding on VLAN member ports.

Syntax

Command Modes

Command History

Default

Usage Information

ip vlan-flooding

To disable, use the no ip vlan-floodingcommand.

CONFIGURATION

Version 9.3(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL platforms

Disabled

By default this command is disabled. There might be some ARP table entries which are resolved through ARP packets which had Ethernet MAC SA different from MAC information inside the ARP packet. This unicast data traffic flooding occurs only for those packets which use these ARP entries.

978 Microsoft Network Load Balancing