Dell 9.7(0.0) manual Ip tacacs source-interface interface

VersionDescription

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.2.1.0 Introduced on the E-Series.

ip tacacs source-interface

Specify an interface’s IP address as the source IP address for TACACS+ connections.

Syntax	ip tacacs source-interface interface
	To delete a source interface, use the no ip tacacs source-interface
	command.
Parameters	interface	Enter the following keywords and slot/port or number

information:

Defaults

Command Modes

Command History

•For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

•For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

•For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

•For a port channel interface, enter the keywords port- channel then a number. The range is from 1 to 128.

•For a Null interface, enter the keyword null then the Null interface number.

•For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

1402 Security