Dell 9.7(0.0) manual Disable, Virtual-address command and enter no disable

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

disable

Disable a VRRP group.

Syntax	disable
	To re-enable a disabled VRRP group, use the no disable command.
Command	VRRP
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

Usage	To enable VRRP traffic, assign an IP address to the VRRP group using the
Information	virtual-address command and enter no disable.
Related	virtual-address — specifies the IP address of the virtual router.
Commands

Virtual Router Redundancy Protocol (VRRP) 1665