Dell 9.7(0.0) manual Show ipv6 neighbors, Trusted-port Interfaces Te 1/1 Dell#

Related Commands

trusted-port Interfaces : Te 1/1

Dell#

•ipv6 nd ra-guard enable — Allows you to configure the RA guard related commands.

•ipv6 nd ra-guard policy — Defines the RA guard policy name and enter the RA guard policy list configuration mode.

•device-role — Specifies the role of the device attached to the port.

•hop-limit — Enables the verification of the advertised hop count limit.

•mtu — Sets the maximum transmission unit (MTU) value.

•other-config-flag — Enables the verification of the advertised other configuration parameter.

•reachable-time — Sets the advertised reachability time.

•retrans-timer — Sets the advertised retransmission time.

•router-preference maximum — Enables the verification of the advertised default router preference (DRP) value.

•trusted-port — Applies the policy to trusted ports.

•ipv6 nd raguard attach-policy — Applies the IPv6 RA guard to a specific interface.

show ipv6 neighbors

Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor addresses stored on the control processor (CP).

S6000

Syntaxshow ipv6 neighbors [vrf vrf-name] [ipv6-address interface

interface]
Parameters	(OPTIONAL) Enter the keyword vrf followed by the name of
vrf vrf-name
	the VRF to display the neighbors corresponding to that VRF.
	NOTE: If you do not specify this option, neighbors
	corresponding to the default VRF are displayed.
ipv6-address	Enter the IPv6 address of the neighbor in the x:x:x:x::x
	format.
	NOTE: The :: notation specifies successive hexadecimal
	fields of zero.
interface	Enter the keyword interface then the interface type and
interface	slot/port or number information:
	• For a port channel interface, enter the keywords port-
	channel then a number.

1036 Neighbor Discovery Protocol (NDP)