Dell 9.7(0.0) manual Ip msdp mesh-group name peer address

VersionDescription

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

6.2.1.1Introduced

ip msdp mesh-group

To be a member of a mesh group, configure a peer.

S6000

Syntax ip msdp mesh-group {name} {peer address}

Parameters

Defaults

Command Modes

Command History

Usage Information

To remove the peer from a mesh group, use the no ip msdp mesh-group {name} {peer address} command.

name	Enter a string of up to 16 characters long for as the mesh
	group name.
peer address	Enter the peer address in a dotted decimal format (A.B.C.D.).
Not configured.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

6.2.1.1Introduced

An MSDP mesh group is a mechanism for reducing SA flooding, typically in an intra-domain setting. When some subset of a domain’s MSDP speakers are fully meshed, they can be configured into a mesh-group. If member X of a mesh-group receives a SA message from an MSDP peer that is also a member of the mesh-

984 Multicast Source Discovery Protocol (MSDP)