ip ecmp-group
Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when
maximum paths are not configured, the CAM can hold a maximum of 16 ecmp per route.
S6000
Syntax ip ecmp-group {maximum-paths | {number} {path-fallback}
To negate a command, use the no ip ecmp-group maximum-paths {number}
command.
Parameters maximum-
paths
Specify the maximum number of ECMP for a route. The
range is 2 to 64.
path-fallback Use the keywords path-fallback to enable this feature. If
you enable the feature, re-enter this keyword to disable the
feature.
Defaults 16
Command
Modes
CONFIGURATION
Command
History Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage
Information
You must save the new ECMP settings to the startup-config (write-mem) then
reload the system for the new settings to take effect.
Related
Commands
show ip cam stack-unit – Display content-addressable memory (CAM) entries for
an S-Series switch.
ip ecmp weighted
Enables weighted ECMP calculations.
Syntax ip ecmp weighted
To disable weighted ECMP calculations, enter the no ip ecmp weighted
command.
Defaults N/A
588 Equal Cost Multi-Path (ECMP)