Dell 9.7(0.0) manual Match interface interface

Related	set community — specifies a COMMUNITY attribute.
Commands

match interface

To match routes whose next hop is on the interface specified, configure a filter.

Syntax	match interface interface
	To remove a match, use the no match interface interface command.
Parameters	interface	Enter the following keywords and slot/port or number

information:

• .

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

• For a port channel interface, enter the keywords port- channel then a number. The range is from 1 to 128.

• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults

Command Modes

Command History

Not configured.

ROUTE-MAP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

248 Access Control Lists (ACL)