Dell 9.7(0.0) manual Snmp-server contact

	Dell(conf)# snmp-server community guest ro security-name
	guestuser
	Dell(conf)#
Example	Dell(conf)# ip access-list standard snmp-ro-acl
	Dell(config-std-nacl)#seq 5 permit host 10.10.10.224
	Dell(config-std-nacl)#seq 10 deny any count
	!
	Dell(conf)#snmp-server community guest ro snmp-ro-acl
	Dell(conf)#
Related	ip access-list standard — names (or selects) a standard access list to filter based on
Commands	IP address.
	ipv6 access-list — configures an access list based on IPv6 addresses or protocols.
	show running-config — displays the current SNMP configuration and defaults.

snmp-server contact

Configure contact information for troubleshooting this SNMP node.

Syntax snmp-server contact text

Parameters

Defaults

Command Modes

Command History

To delete the SNMP server contact information, use the no snmp-server contact command.

text Enter an alphanumeric text string, up to 55 characters long.

none

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

1482 Simple Network Management Protocol (SNMP) and Syslog