Dell 9.7(0.0) manual Garp timers, Parameters Defaults Command Modes Command History Join, Leave

garp timers

Set the intervals (in milliseconds) for sending GARP messages.

S6000

Syntax	garp timers {join leave leave-all}
	To return to the previous setting, use the no garp timers {join leave
	leave-all} command.

Parameters

Defaults

Command Modes

Command History

join	Enter the keyword join then the number of milliseconds to
	configure the join time. The range is from 100 to 147483647
	milliseconds. The default is 200 milliseconds.
	NOTE: Designate the milliseconds in multiples of 100.
leave	Enter the keyword leave then the number of milliseconds
	to configure the leave time. The range is from 100 to
	2147483647 milliseconds. The default is 600 milliseconds.
	NOTE: Designate the milliseconds in multiples of 100.
leave-all	Enter the keywords leave-allthen the number of
	milliseconds to configure the leave-all time. The range is
	from 100 to 2147483647 milliseconds. The default is 1000
	milliseconds.
	NOTE: Designate the milliseconds in multiples of 100.

As above.

CONFIGURATION-GVRP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on C-Series, E-Series, and S-Series

GARP VLAN Registration (GVRP) 627