have no members if there are not enough ports installed. In the S-Series, stack members can provide those ports.

NOTE: The Dell Networking OS implementation of LAG or Port Channel requires that you configure a LAG on both switches manually. For information about Dell Networking OS link aggregation control protocol (LACP) for dynamic LAGs, refer to the Link Aggregation Control Protocol (LACP) chapter. For more information about configuring and using Port Channels, refer to the Dell Networking OS Configuration Guide.

channel-member

Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.

S6000

Syntax

channel-member interface

 

To delete an interface from a Port Channel, use the no channel-member

 

interface command.

Parameters

(OPTIONAL) Enter any of the following keywords and slot/

interface

 

port or number information:

Defaults

Command Modes

Command History

•For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/port information.

•For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

•For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

Not configured.

INTERFACE PORTCHANNEL

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

Interfaces

729

Page 729
Image 729
Dell 9.7(0.0) manual Channel-member interface, Interface command, Port or number information