Dell 9.7(0.0) manual Snmp trap link-status

Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only.

Defaults

Command Modes

Command History

Usage Information

Related Commands

Not Enabled.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.4(0.0)	Introduced on the S-Series and Z9000.

Use this command to bind an SNMP agent to a VRF. The SNMP agent processes the requests from the interfaces that belong to the specified VRF. If no VRF is specified, then the default VRF is used.

show snmp user — displays the information configured on each SNMP user name.

snmp trap link-status

Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.

Syntax snmp trap link-status

Defaults

Command Modes

Command History

To disable sending link trap messages, use the no snmp trap link-statuscommand.

Enabled.

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.2(0.0)

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

1500 Simple Network Management Protocol (SNMP) and Syslog