Dell 9.7(0.0) - page 162

Parameters vlan-id Enter the VLAN Identifier. The range is from 1 to 4094.

max-attempts

number

(OPTIONAL) Enter the keywords max-attempts followed

number of attempts desired before authentication fails. The

range is from 1 to 5. The default is 3.

Defaults 3 attempts

Command

Modes

CONFIGURATION (conf-if-interface-slot/port)

Command

History This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

8.4.1.0 Introduced on the C-Series and S-Series.

Usage

Information If the host responds to 802.1X with an incorrect login/password, the login fails. The

switch attempts to authenticate again until the maximum attempts configured is

reached. If the authentication fails after all allowed attempts, the interface moves

to the authentication failed VLAN.

After the authentication VLAN is assigned, the port-state must be toggled to restart

authentication. Authentication occurs at the next reauthentication interval (dot1x

reauthentication).

Commands •dot1x port-control — Enable port control on an interface

•dot1x guest-vlan — Configure a guest VLAN for limited access users or for

devices that are not 802.1X capable.

•show dot1x interface — Display the 802.1X configuration of an interface.

162 802.1X