Related Commands

VersionDescription

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.3.1.0On the E-Series, available in INTERFACE VLAN context, reduced the minimum aging time in the INTERFACE VLAN context from 10 seconds to 1 second.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.2.1.1

Introduced on the E-Series.

mac learning-limit — sets the MAC address learning limits for a selected interface.

show mac-address-tableaging-time — displays the MAC aging time.

mac-address-table static

Associate specific MAC or hardware addresses to an interface and VLANs.

S6000

Syntaxmac-address-table static mac-address{multicast vlan vlan-idoutput—range interface}{output interface vlan vlan-id}

To remove a MAC address, use the no mac-address-table static mac- address output interface vlan vlan-idcommand.

Parameters

mac-address

Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn

 

format.

multicast

Enter a vlan port to where L2 multicast MAC traffic is

 

forwarded.

 

NOTE: Use this option if you want multicast functionality

 

in an L2 VLAN without IGMP protocols.

output

For a unicast MAC address, enter the keyword output then

interface

one of the following interfaces for which traffic is forwarded:

 

• For a 10-Gigabit Ethernet interface, enter the keyword

 

TenGigabitEthernet then the slot/port information.

 

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

 

• For a port channel interface, enter the keywords port-

 

channel then a number. The range is from 1 to 128.

Layer 2

919

Page 919
Image 919
Dell 9.7(0.0) manual Mac-address-table static, Multicast