Marantz SR4400 manual English, General Malfunction, How To Reset The Unit, Memory backup

SYMPTOM	CAUSE	REMEDY
Can not select CSII mode.	Input signal is incompatible.	Use PCM input signal or analog input signal.
No output to Sub Woofer Out.	Sub-woofer = NONE has been selected	Select Sub-woofer = YES.
	in SETUP mode.
Noise is produced during DTS-	Analog has been selected for input.	Be sure to perform digital connection, select digital
encoded CD or laser disc play.		input, then play.
A specific channel does not	Nothing recorded on source.	Check the encoded channel on the source side.
produce output.
FM or AM reception fails.	Antenna connection is incomplete.	Correctly connect the indoor FM and AM antennas
		to FM and AM antenna outlets.

GENERAL MALFUNCTION

If the equipment malfunctions, this may be because an electrostatic discharge or AC line interference has corrupted the information in the equipment memory circuits. Therefore:

-disconnect the plug from the AC line supply

-after waiting at least three minutes, reconnect the plug to the AC line supply

-re-attempt to operate the equipment

HOW TO RESET THE UNIT

AVAV SURROUNDSURROUND RECEIVERRECEIVER SR4400SR4400

	SURROUND								VOLUME
								DOWN	UP
		CLEARCLEAR	MEMORYMEMORY	TUNING/PRESET		F/P	MODE
		A/D	HT-EQ			DISPLAY		MUTE
POWER ON/STANDBY	PHONES	6.1 CHCH--ININ		VCR1	CDR/MD	TAPE	CD	TUNER

ENGLISH

Noise is heard during AM	Reception is affected by other electrical	Try changing location where the AM indoor
reception.	fields.	antenna is set up.
Noise is heard during FM	The radio waves from the broadcasting	Install an FM outdoor antenna.
reception.	station are weak.
C a n n o t g e t p r o g r a m m e d	Preset data has been erased.	Disconnecting power plug for long periods of time
station when the PRESET		will erase preset data. If that happens, input the
button is pressed.		preset data again.
Control with the remote control	Batteries are consumed.	Replace all the batteries with new ones.
unit fails.
	Remote controller's function - key	Select different position from which equipment will
	setting is wrong.	be controlled.
	The distance between this SR4400 and	Move closer to this SR4400.
	the remote commander is too far.
	Something is blocking SR4400 and the	Remove offending object.
	remote commander.

Memory backup

•In case a power outage occurs or the power cord is accidentally unplugged, the SR4400 is equipped with a backup function to prevent memory data such as the preset memory from being erased.

Should the operation or display seem to be abnormal, reset the unit with the following procedure.

The SR4400 is turned on, press and hold the CLEAR and MEMORY buttons simultaneously for 3 seconds or more.

Remember that the procedure will reset the settings of the function selector, Surround mode, delay time, TUNER PRESET etc., to their initial settings.

29