Preparing for Vacation
For long vacations or absences, set both power switches (on the back of the dispenser) to the 0 (off) position.
1.Unplug the water dispenser.
2.Remove the water bottle.
3.Drain the water tanks (see Draining the Dispenser).
4.Dry the separator thoroughly on both the top and bottom (see Cleaning the Separator).
After returning from vacation, make sure to sanitize the water tanks before using the dispenser (see Cleaning and Sanitizing the Water Tank).
Specifications
Chilling Rate: approx. 0.5 gallons (2 liters) per hour | Capacity: 3 or 5 gallon bottle |
Heating Rate: approx. 0.8 gallons (3 liters) per hour | Power Consumption: Heating: |
| Cooling: |
Troubleshooting Tips.
Problem |
| Possible Causes | What To Do |
|
|
|
|
Water has poor taste |
| Separator needs cleaning. | •See Cleaning the Separator. |
or odor |
|
|
|
| Unit needs to be sanitized. | •See Cleaning and Sanitizing the Water Tanks. | |
|
| ||
|
|
|
|
Water not hot enough |
| Dispenser is unplugged. | • Push the plug completely into the outlet. |
or cold enough |
|
|
|
| The fuse is blown/circuit | • Replace house fuse or reset the house circuit breaker. | |
|
| ||
|
| breaker is tripped. | • If too many items are plugged into a single circuit, move |
|
|
| some items to a different circuit. |
All the water in the water tank has been used.
•Wait 30 minutes for water to heat or cool.
| Temperature limiter tripped. | •Set the HOT and COLD power switches (on the back of the | |
|
| dispenser) to the 0 (off) position. Wait five minutes; then | |
|
| set the switches to the I (on) position. Wait 30 minutes for | |
|
| water to heat or cool. | |
|
|
| |
Water dispenser does | Empty water bottle. | •Replace with a new bottle of water. | |
not work |
|
| |
Mineral deposits clogging tanks. | •See Care and Cleaning. | ||
| |||
|
|
| |
Water dispenser leaks | Crack or pin hole in bottle. | • Replace with a new bottle of water. | |
from the outside |
|
| |
|
|
| |
Water dispenser is noisy | Water dispenser is uneven. | • Make sure the water is installed on a level floor or counter | |
|
| strong enough to support it when fully loaded. | |
|
|
| |
| Bottle making a gurgling noise | •This is normal. | |
| as water fills the tanks. |
| |
|
|
| |
| Hot water boiling sound. | •This is normal. | |
|
|
| |
| Dispenser or water bottle shakes | •This is normal. | |
| when the cooling system cycles off. |
| |
|
|
| |
Particles floating in | Water has high mineral content. | •Find a water source with lower hardness. | |
water |
|
| |
|
|
| |
Water in bottle is hot | Water is boiling in the hot tank | • Press the hot dispenser button until water flows to remove | |
| and bubbling up into the bottle. | air from the hot tank. | |
|
|
| |
Foul odor in air around | Hot water tank is empty or not | • Press the hot dispenser button until water flows to remove | |
dispenser | completely full. | air from the hot tank. |
7
