Using the water dispenser.
GXCF05D Floor model
GXCC01D
Countertop model
Features and Parts List
Bottle Support Collar (WS28X10012)
Separator (WS28X10013)
Cold Water Tank
Hot (Red) and Cold (Blue) Power Switches
(back of dispenser)
Indicator Lights
The green light will be lit when the dispenser is plugged in. The red and blue lights will cycle on and off while the dispenser heats and cools water.
Hot (Red) and Cold (Blue) Water Dispenser Buttons
Dispenser Drip Tray (WS28X10016) and
Grille (WS28X10015)
Storage Cabinet
Do not use to store foods requiring refrigeration. The cabinet is not refrigerated.
Shelf (WS28X10014)
Drainage Cap (floor models) (WS01X10008)
Silicon Stopper (floor models) (WS01X10007)
Retaining Clip (countertop models) (WS01X10010)
Rubber Drain Cover (countertop models) (WS01X10011)
Loading the Dispenser
IMPORTANT: Make sure the dispenser is unplugged with both the hot and cold power switches (on the back of the dispenser) set to the 0 (off) position. Before placing the water bottle on the dispenser, wash hands and wipe the top of the bottle with a clean cloth. Avoid touching the part of the bottle that will be in contact with the water dispenser.
Make sure the water level in the top of the dispenser is low enough to allow for proper bottle installation. Failure to do so may cause the dispenser to overflow.
Sanitize the dispenser water tanks prior to installing a full bottle of water for the first time (see “Cleaning and Sanitizing the Water Tanks”).
1.If the water bottle has a cap, push the center plug out of the cap and into the bottle before placing on the dispenser.
2.Place the bottle on top of the dispenser as shown and into the bottle support collar. Install the bottle quickly to minimize spills.
3.IMPORTANT: Press the hot and cold dispenser buttons until water runs from both taps.
4.Plug in the dispenser.
5.Set the HOT and COLD power switches (located on the top left rear of the dispenser) to the I (on) position.
6.Allow 30 minutes for water to reach hot and cold temperatures.
Contact a local water bottle distributor to purchase water bottles.
Child
safeguard tab
Child Safeguard
The HOT dispenser button is equipped with a child safeguard that reduces the risk of hot water being dispensed accidentally or by small children. To use the button, slide the tab up and press the button in.
The dispenser heats water to a temperature
of approximately 190°F (88°C). Water temperatures above 125°F (52°C) can cause severe burns or death from scalding. Children, the disabled and the elderly are at highest risk of being scalded.
CAUTION: Children should be supervised by a parent when using this product.
4
