Care and cleaning of the dispenser.
Cleaning the Outside and Storage Cabinet (on some models)
IMPORTANT: Set both power switches (on the back of the dispenser) in the 0 (off) position and unplug the water dispenser before cleaning.
The inside and outside of the cabinet can be washed with mild soap and water. Rinse thoroughly with clear water. Never use commercial cleaners or abrasive scouring powders.
Sweep away or vacuum any dust from the condenser coils on the back of the unit. For best results, use a brush specially designed for this purpose. It is available at most appliance stores.
Drip tray grille
Drip tray
Cleaning the Drip Tray and Grille
The dispenser drip tray is not
Clean with mild soap or on the top rack in the dishwasher.
Draining the Dispenser
The dispenser should be drained before cleaning the tanks and before leaving for long vacations or absences.
Drain outlet cap
Floor models
(rear of dispenser)
Floor Models
1.Set both power switches (on the back of the dispenser) in the 0 (off) position and unplug the dispenser.
2.Remove the water bottle from the dispenser.
3.Put a container that will withstand hot water under the hot water tap. Press the HOT dispenser button until the water is cool (about 1 quart). Add water to the cold water reservoir (on top where the bottle supplies water) as needed.
4.Dispense water from both buttons into container(s) until no more water can be dispensed (about 1 quart of water still remains in the dispenser).
5.Place a large bucket beneath the drain outlet on the rear of the dispenser.
6.Using a Phillips screwdriver, loosen the screws on the bracket covering the drain outlet cap. Rotate the bracket out of the way to allow access to the cap.
7.Remove the cap and silicon stopper from the drain outlet and and allow water to drain. After draining, replace the stopper and cap.
8.Rotate the bracket back into place and tighten screws.
Make sure to install a full bottle and dispense water from the hot water tap before plugging in and turning on the dispenser (see Loading the Dispenser).
Drain cover and
retaining clip
Countertop models (bottom of dispenser)
Countertop Models
1.Set both power switches (on the back of the dispenser) in the 0 (off) position and unplug the dispenser.
2.Remove the water bottle from the dispenser.
3.Put a container that will withstand hot water under the hot water tap. Press the HOT dispenser button until the water is cool (about 1 quart). Add water to the cold water reservoir (on top where the bottle supplies water) as needed.
4.Dispense water from both buttons into container(s) until no more water can be dispensed (about 1 quart of water still remains in the dispenser).
WARNING: Lift the dispenser carefully; it weighs approximately 40 lbs (18 kg). Avoid accidentally pressing the dispenser buttons while lifting or carrying.
5.Place the dispenser over a sink with 3 feet on the counter. Hold or secure the dispenser steady while removing the retaining clip and drain cover. Remove the retaining clip and drain cover from the drain outlet, making sure not to damage the drain cover. Allow water to drain.
6.After draining, replace the drain cover and retaining clip.
Make sure to install a full bottle and dispense water from the hot water tap before plugging in and turning on the dispenser (see Loading the Dispenser).
5
