Dell 9.7(0.0) manual Ipv4 vrf vrf, Ipv6 unicast

Parameters

Defaults

Command Modes

Command History

ipv4 multicast	Enter the keyword ipv4 followed by the keyword
	multicast to enable BGPv4 multicast mode.
ipv4 vrf vrf-	Enter the keyword ipv4 followed by the keyword vrf and
name	then the name of the VRF to enable VRF mode.
	NOTE: Use this attribute to start a BGP instance
	corresponding to either a specific address family in a
	default VRF or an IPv4 address family in a non-default
	VRF.
ipv6 unicast	Enter the keyword ipv6 followed by the keyword unicast
	to enable BGPv6 mode.
vrf vrf-name	(Optional) Enter the keyword vrf followed by the name of
	the VRF to install the IPv6 route in that VRF.
	NOTE: It will not be possible to enable VRF mode for
	IPv6 unicast without configuring the corresponding IPv4
	unicast mode for the same VRF. While deletion,
	whenever the IPv4 VRF mode is deleted for the VRF, it
	will automatically delete the IPv6 VRF configurations as
	well.
Not configured.
ROUTER BGP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Added support for IPv6 VRF.
9.4.(0.0)	Added support for VRF.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

6.5.1.0Introduced

Border Gateway Protocol 337