Dell 9.7(0.0) manual Fast-convergence number

Command Modes

Command History

Usage Information

ROUTER OSPF

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Added support for the Multi-Process OSPF.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

The distribute-list out command applies to routes autonomous system boundary routers (ASBRs) redistributes into OSPF. It can be applied to external type 2 and external type 1 routes, but not to intra-area and inter-area routes.

fast-convergence

This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route computation so that convergence takes less time.

S6000

Syntax	fast-convergence {number}
	To cancel fast-convergence, use the no fast convergence command.
Parameters	number	Enter the convergence level desired. The higher this
		parameter is set, the faster OSPF converge takes place. The
		range is from 1 to 4.
Defaults	none.
Command	ROUTER OSPF
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

1076 Open Shortest Path First (OSPFv2 and OSPFv3)