Dell 9.7(0.0) manual This command is intended for low-speed interfaces

	Version	Description
	9.7(0.0)	Introduced on the S6000-ON.
	9.0.2.0	Introduced on the S6000.
	8.3.19.0	Introduced on the S4820T.
	8.3.11.1	Introduced on the Z9000.
	8.3.7.0	Introduced on the S4810.
	7.8.1.0	Introduced on the S-Series.
	7.6.1.0	Introduced on the C-Series.
	pre- 6.2.1.1	Introduced on the E-Series.
Usage	This command is intended for low-speed interfaces.
Information

passive-interface

Suppress routing updates on a specified interface.

S6000

Syntax	passive-interface interface
	To delete a passive interface, use the no passive-interfaceinterface
	command.
Parameters	interface	Enter the following information:
		• For a Port Channel interface, enter the keywords port-
		channel then a number. The range is from 1 to 128.
		• For a 10-Gigabit Ethernet interface, enter the keyword
		TenGigabitEthernet then the slot/port information.
		• For a 40-Gigabit Ethernet interface, enter the keyword
		fortyGigE then the slot/port information.
		• For a VLAN, enter the keyword vlan then a number from
		1 to 4094.
Defaults	Not configured.
Command	ROUTER RIP
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

1318 Routing Information Protocol (RIP)