Dell 9.7(0.0) manual Deny udp, Total Ports

Example

Related Commands

Total Ports: 4001

An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.

Rule#	Data	Mask	From	To	#Covered
1 0000000000000000		1111110000000000	0	1023	1024
Total	Ports: 1024

deny — assigns a filter to deny IP traffic.

deny udp — assigns a filter to deny UDP traffic.

deny udp

To drop user datagram protocol (UDP) packets meeting the filter criteria, configure a filter.

Syntaxdeny udp {source mask any host ip-address} [operator port [port]] {destination mask any host ip-address} [dscp] [operator port [port]] [count [byte] [order] [fragments]

To remove this filter, you have two choices:

•Use the no seq sequence-numbercommand if you know the filter’s sequence number.

•Use the no deny udp {source mask any host ip-address} {destination mask any host ip-address} command.

Parameters	source	Enter the IP address of the network or host from which the
		packets were sent.
	mask	Enter a network mask in /prefix format (/x) or A.B.C.D. The
		mask, when specified in A.B.C.D format, may be either
		contiguous or non-contiguous.
	any	Enter the keyword any to specify that all routes are subject
		to the filter.
	host ip-address	Enter the keyword host then the IP address to specify a host
		IP address.
	dscp	Enter this keyword dscp to deny a packet based on the
		DSCP value. The range is from 0 to 63.
	operator	(OPTIONAL) Enter one of the following logical operand:
		• eq = equal to
		• neq = not equal to
		• gt = greater than
		• lt = less than
		• range = inclusive range of ports (you must specify two
		ports for the port command)

Access Control Lists (ACL) 205