Dell 9.7(0.0) manual OSPFv3 Commands, Area authentication, Area area-id, Ipsec spi number

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.8.0Introduced on the S4810.

OSPFv3 Commands

Open shortest path first version 3 (OSPFv3) for IPv6 is supported on the platform.

The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on) remain unchanged. However, OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most changes were necessary to handle the increased address size of IPv6.

The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.

area authentication

Configure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.

Syntaxarea area-idauthentication ipsec spi number {MD5 SHA1} [key- encryption-type] key

Parameters

area area-id

ipsec spi number

MD5 SHA1

key- encryption- type

Area for which OSPFv3 traffic is to be authenticated. For area-id, you can enter a number.

The range is from 0 to 4294967295.

Security Policy index (SPI) value that identifies an IPsec security policy.

The range is from 256 to 4294967295.

Authentication type: Message Digest 5 (MD5) or Secure Hash Algorithm 1 (SHA-1).

(OPTIONAL) Specifies if the key is encrypted.

The values are 0 (key is not encrypted) or 7 (key is encrypted).

1142 Open Shortest Path First (OSPFv2 and OSPFv3)