Command History

Usage Information

Example

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Added ipv4 multicast and ipv6 unicast parameters.

9.4.(0.0)

Added support for VRF.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

The show ip bgp community-listcommand without any parameters lists BGP routes matching the Community List and the output is the same as for the show ip bgp command output.

The following describes the show ip bgp community-list pass command shown in the following example.

Field

Description

Network

Displays the destination network prefix of each BGP route.

Next Hop

Displays the next hop address of the BGP router. If 0.0.0.0 is

 

listed in this column, then local routes exist in the routing

 

table.

Metric

Displays the BGP route’s metric, if assigned.

LocPrf

Displays the BGP LOCAL_PREF attribute for the route.

Weight

Displays the route’s weight.

Path

Lists all the ASs the route passed through to reach the

 

destination network.

Dell#conf t

Dell(conf)#ip community-list cl1 Dell(config-community-list)#permit 1000:1 Dell(config-community-list)#end Dell#show ip bgp community-list cl1

BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0 BGP local router ID is 192.168.11.5

Status codes: s suppressed, S stale, d dampened, h history, * valid, > best

Path source: I - internal, a - aggregate, c - confed-external,

424

Border Gateway Protocol

Page 424
Image 424
Dell 9.7(0.0) manual 424