Dell 9.7(0.0) manual Show ipv6 nd ra-guard policy, Trusted-port Dellconf-raguardpolicylist#

Related Commands

trusted-port Dell(conf-ra_guard_policy_list)#

•ipv6 nd ra-guard enable — Allows you to configure the RA guard related commands.

•ipv6 nd ra-guard policy — Defines the RA guard policy name and enter the RA guard policy list configuration mode.

•device-role — Specifies the role of the device attached to the port.

•hop-limit — Enables the verification of the advertised hop count limit.

•mtu — Sets the maximum transmission unit (MTU) value.

•other-config-flag — Enables the verification of the advertised other configuration parameter.

•reachable-time — Sets the advertised reachability time.

•retrans-timer — Sets the advertised retransmission time.

•router-preference maximum — Enables the verification of the advertised default router preference (DRP) value.

•trusted-port — Applies the policy to trusted ports.

show ipv6 nd ra-guard policy

Display the configurations applied on all the RA guard policies or a specific RA guard policy.

Syntax	show ipv6 nd ra-guard policy policy-name
Parameter	policy policy-	Enter the keyword policy then the policy name. The policy
	name	name allows a maximum of 140 characters.

Command Modes

Command History

Example

EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.7(0.0)	Introduced on the S4810, S4820T, S5000, S6000, and
	Z9000 switches.

Dell#show ipv6 nd ra-guard policy test

ipv6 nd ra-guard policy test device-role router

hop-limit maximum 1

match ra ipv6-access-list access other-config-flag on router-preference maximum medium

Neighbor Discovery Protocol (NDP) 1035