Dell 9.7(0.0) manual Mac-address-table station-move refresh-arp, Mac learning-limit, Addresslimit

mac-address-table station-move refresh-arp

Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology change.

S6000

Syntax	[no] mac-address-table station-move refresh-arp
Defaults	none
Command	CONFIGURATION
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

7.4.1.0Introduced on the E-Series.

Usage	For details about using this command, refer to the “NIC Teaming” section of the
Information	Layer 2 chapter in the Dell Networking OS Configuration Guide.

mac learning-limit

Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.

S6000

Syntax

Parameters

mac learning-limit address_limit [vlan vlan-id] [station-move- violation [dynamic]] [dynamic [no-station-move station-move]]

address_limit	Enter the maximum number of MAC addresses that can be
	learned on the interface. The range is from 1 to 1000000.
vlan vlan-id	Enter the keyword then the VLAN ID. The range is from 1 to
	4094.
dynamic	(OPTIONAL) Enter the keyword dynamic to allow aging of
	MACs even though a learning limit is configured.

Layer 2 921