Common IP ACL Commands

The following commands are available within both Ingress and Egress IP ACL modes (Standard and Extended) and do not have mode-specific options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an implicit permit.

The supports both Ingress and Egress IP ACLs.

NOTE: Also refer to the Commands Common to all ACL Types section.

access-class

Apply a standard ACL to a terminal line.

Syntax

Parameters

Defaults

Command Modes

Command History

access-classaccess-list-name

To remove an ACL, use the no access-classaccess-list-namecommand.

access-list-

Enter the name of a configured Standard ACL, up to 140

name

characters.

Not configured.

 

LINE

 

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.8.1.0Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to 16 characters long.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

Access Control Lists (ACL)

185

Page 185
Image 185
Dell 9.7(0.0) manual Common IP ACL Commands, Access-class, Access-list