4qJAoBwtneOXfLBcHF3V2hcMIqaZN+CRCnw/

 

zCMlnCf0+qVTd1oofsea5r09kS0xTp0CNfHXZ3NuGCq9Ov33m9+U9tMwhS8vy8A

 

VxdH4x4km3c3t5Jvc=

 

freedom@poclab4

 

Dell#

Related

ip ssh rsa-authentication (Config) — configures the RSA authorized keys.

Commands

 

ssh

Open an SSH connection specifying the hostname, username, encryption cipher, HMAC algorithm, port number, and version of the SSH client.

Syntax

Parameters

NOTE: Some of the parameters in this command require licensing to access. For more information, contact your Dell Networking representative.

ssh [vrf vrf-name] {hostname ipv4 address ipv6 address} [-c encryption cipher -l username -m HMAC algorithm -p port- number -v {1 2}]

vrf vrf-name

(OPTIONAL) Enter the keyword vrf aand then the name of

 

the VRF to specify the VRF used with the SSH session.

 

NOTE: The VRF configured using this command has a

 

higher precedence than the VRF configured using the ip

 

ssh vrf vrf-namecommand. If you do not configure

 

a VRF using this command, then the SSH client uses the

 

configured VRF (if any). If there is a mismatch between

 

VRFs that are configured using the ip ssh source-

 

interface command and the ssh vrf vrf-name

 

command, then an error is reported.

hostname

(OPTIONAL) Enter the IP address or the host name of the

 

remote device.

vrf instance

(OPTIONAL) E-Series Only: Enter the keyword vrf then the

 

VRF Instance name to open an SSH connection to that

 

instance.

ipv4 address

(OPTIONAL) Enter the IP address in dotted decimal format

 

A.B.C.D.

ipv6-address

(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format

prefix-length

then the prefix length in the /x format. The range is from /0

 

to /128.

 

NOTE: The :: notation specifies successive hexadecimal

 

fields of zeros.

-cencryption

Enable the “FIPS mode enable", this mode will support only

cipher

v2 client.

1442

Security

Page 1442
Image 1442
Dell 9.7(0.0) manual Ssh, Ipv4 address, Cipher