Dell 9.7(0.0) manual Set tag, Set origin igp egp incomplete

set origin

To manipulate the BGP ORIGIN attribute, configure a filter.

Syntax

Parameters

Defaults

Command Modes

Command History

set origin {igp egp incomplete}

To delete an ORIGIN attribute setting, use the no set origin command.

egp	Enter the keyword egp to set routes originating from outside
	the local AS.
igp	Enter the keyword igp to set routes originating within the
	same AS.
incomplete	Enter the keyword incomplete to set routes with
	incomplete routing information.
Not configured.
ROUTE-MAP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0 Introduced on the E-Series.

set tag

To specify a tag for redistributed routes, configure a filter.

Syntax	set tag tag-value
	To delete a setting, use the no set tag command.

Access Control Lists (ACL) 267