Dell 9.7(0.0) manual Storm-control broadcast Configuration

Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only.

•For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

•For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

•For a port channel interface, enter the keywords port- channel then a number.

Defaults

Command Modes

Command History

none

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.2(0.0)

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.5.1.0Introduced on the E-Series.

storm-control broadcast (Configuration)

Configure the percentage of broadcast traffic allowed in the network.

Syntaxstorm-control broadcast [packets_per_second in]

To disable broadcast rate-limiting, use the no storm-control broadcast [packets_per_second in] command.

storm-control broadcast [percentage decimal_value in out] [wred- profile name]][packets_per_second in]

1544 Storm Control