Dell 9.7(0.0) manual Commands to Configure Secure Dhcp, Arp inspection

VersionDescription

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on the C-Series and S-Series.

Commands to Configure Secure DHCP

DHCP, as defined by RFC 2131, provides no authentication or security mechanisms. Secure DHCP is a suite of features that protects networks that use dynamic address allocation from spoofing and attacks.

arp inspection

Enable dynamic arp inspection (DAI) on a VLAN.

S6000

Syntax	arp inspection
Defaults	Disabled
Command	INTERFACE VLAN
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.3.1.0Introduced on the E-Series.

8.2.1.0Introduced on the C-Series and S-Series.

Related	arp inspection-trust — specifies a port as trusted so that ARP frames are not
Commands	validated against the binding table.

Dynamic Host Configuration Protocol (DHCP) 559