Dell 9.7(0.0) manual Track resolution ip route, Isis resolution, Resolution

track resolution ip route

Configure the protocol-specific resolution value used to scale an IPv4 route metric.

Syntaxtrack resolution ip route {isis resolution-value ospf resolution-value}

To return to the default setting, use the no track object-idcommand.

Parameters

Defaults

Command Modes

Command History

Usage Information

object-id	Enter the ID number of the tracked object. The range is 1 to
	500.
isis resolution-	Enter the resolution used to convert the metric in the routing
value	table for ISIS routes to a scaled metric.
ospf	Enter the resolution used to convert the metric in the routing
resolution-	table for OSPF routes to a scaled metric.
value
none
CONFIGURATION

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

8.3.12.0Introduced on the S4810.

8.4.1.0Introduced.

Use this command to configure the protocol-specific resolution value that converts the actual metric of an IPv4 route in the routing table to a scaled metric in the range 0 to 255.

The UP/DOWN state of a tracked IPv4 route is determined by a user-configurable threshold (the threshold metric command) for the route’s metric in the routing table. To provide a common tracking interface for different clients, route metrics are scaled in the range 0 to 255, where 0 is connected and 255 is inaccessible.

The protocol-specific resolution value calculates the scaled metric by dividing a route's cost by the resolution value set for the route protocol:

•For ISIS, you can set the resolution in the range 1 to 1000, where the default is 10.

•For OSPF, you can set the resolution in the range 1 to 1592, where the default is 1.

•The resolution value used to map static routes is not configurable. By default, Dell Networking OS assigns a metric of 0 to static routes.

Object Tracking 1051