Dell 9.7(0.0) - page 1309

interface (OPTIONAL) Identifies the interface type slot/port as one of

the following:

• For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

• For a VLAN, enter the keyword vlan then a number from

1 to 4094.

connected (OPTIONAL) Enter the keyword connected to filter only

directly connected routes.

isis (OPTIONAL) Enter the keyword isis to filter only IS-IS

routes.

ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.

static (OPTIONAL) Enter the keyword static to filter manually

configured routes.

Defaults Not configured.

Command

Modes

ROUTER RIP

Command

History This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

Commands

ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.

Routing Information Protocol (RIP) 1309