8

Boot Command Line Interface

To access this BOOT_USER mode, first boot your Dell Networking platform. When you see the “Press ESC to stop auto-boot”, press the ESC key to log into BCLI

You enter BOOT_USER mode immediately, as indicated by the BOOT_USER# prompt.

NOTE: All commands in this chapter are in Boot_User mode. These commands are supported on the Dell Networking platform.

You cannot use the Tab key to complete commands in this mode.

boot change

Change the primary, secondary, or default Dell Networking OS boot configuration.

Syntax

boot change primary secondary default}

Parameters

primary

Enter the keyword primary to configure the boot parameters

 

 

 

used in the first attempt to boot Dell Networking OS.

 

secondary

Enter the keyword secondary to configure boot parameters

 

 

used if the primary operating system boot selection is not

 

 

available.

default

Defaults

None

Command

BOOT_USER

Modes

 

Command

Version 9.0.2.0

History

 

Enter the keyword default to configure boot parameters used if the secondary operating system boot parameter selection is not available. You can configure this option to any of the available type, for example flash/usb/ftp/tftp.

Introduced on the S6000.

Boot Command Line Interface

323

Page 323
Image 323
Dell 9.7(0.0) manual Boot Command Line Interface, Boot change, Primary, Secondary, Default