Dell 9.7(0.0) manual Max-metric router-lsa, Series, E-Series, Z-Series, S4810

maximum-paths

Enable the software to forward packets over multiple paths.

Syntax maximum-paths number

Parameters

Defaults

Command Modes

Command History

To disable packet forwarding over multiple paths, use the no maximum-pathscommand.

number	Specify the number of paths. The range is from 1 to 64. The
	default is 8 paths.
8
ROUTER OSPF

VersionDescription

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Added support for Multi-Process OSPF.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.1 Introduced on the E-Series.

max-metric router-lsa

Configure the maximum cost of 65535 on a new router so that it functions as a stub router in the network and OSPF traffic destined to other networks is not forwarded on a path through the router.

C-Series, E-Series, Z-Series, S4810

Syntax	max-metric router-lsa [on-startup {announce-timewait-for-bgp [wait-
	time]}]
	To remove the maximum metric assignment from an OSPF router and send LSAs
	with the currently configured cost, enter no max-metric router-lsa [on-startup
	{announce-time wait-for-bgp[wait-time]}].

Parameters

on-startup announce-time

Enter the time (in seconds) following boot-up during which the maximum cost (65535) for transmitting OSPF traffic on router interfaces is announced in LSAs and the router functions as a stub router.

Open Shortest Path First (OSPFv2 and OSPFv3) 1161