Command Modes

Command History

Usage Information

Related Commands

std-access-listSpecify the standard IP access list that contains the mapping rules for multicast groups.

source-addressSpecify the multicast source address to which the groups are mapped.

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

Version 9.7(0.0)

Added support for VRF and Introduced on the S6000-ON.

Version 9.5(0.0)

Introduced on the Z9500.

Version 9.0.2.0

Introduced on the S6000.

Version 8.3.19.0

Introduced on the S4820T.

Version 8.3.11.1

Introduced on the Z9000.

Version 8.3.7.0

Introduced on the S4810.

Version 7.8.1.0

Introduced on the C-Series and S-Series.

Version 7.7.1.0

Introduced on the E-Series.

Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups. You may not use extended access lists with this command. When you configure a static SSM map and the router cannot find any matching access lists, the router continues to accept (*,G) groups.

ip access-list standard — creates a standard access list to filter based on IP address.

ip igmp version

Manually set the version of the router to IGMPv2 or IGMPv3.

S6000

Syntax

ip igmp version {2 3}

Parameters

2

Enter the number 2 to set the IGMP version number to

 

 

 

IGMPv2.

 

3

Enter the number 3 to set the IGMP version number to

 

 

IGMPv3.

Defaults

2 (that is, IGMPv2)

 

646

Internet Group Management Protocol (IGMP)

Page 646
Image 646
Dell 9.7(0.0) manual Ip igmp version 2