Usage Information

Related Commands

VersionDescription

8.3.7.0Introduced on the S4810.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

E-Series legacy command

Syslog messages contain the IP address of the interface used to egress the router. By configuring the logging source-interfacecommand, the Syslog packets contain the IP address of the interface configured.

logging — enables logging to the Syslog server.

logging synchronous

Synchronize unsolicited messages and Dell Networking OS output.

Syntaxlogging synchronous [level level all] [limit number-of-

buffers]

Parameters

Defaults

Command Modes

Command History

To disable message synchronization, use the no logging synchronous [level level all] [limit number-of-buffers]command.

all

Enter the keyword all to ensure that all levels are printed

 

asynchronously.

level level

Enter the keyword level then a number as the severity

 

level. A high number indicates a low severity level and vice

 

versa. The range is from 0 to 7. The default is 2.

all

Enter the keyword all to turn off all.

limit number-

Enter the keyword limit then the number of buffers to be

of-buffers

queued for the terminal after which new messages are

 

dropped. The range is from 20 to 300. The default is 20.

Disabled. If enabled without the level or number-of-buffersoptions specified, level = 2 and number-of-buffers = 20 are the defaults.

LINE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

1516

Simple Network Management Protocol (SNMP) and Syslog

Page 1516
Image 1516
Dell 9.7(0.0) Logging synchronous, Syntaxlogging synchronous level level all limit number-of, Limit number, Of-buffers