Dell 9.7(0.0) Cam-acl-egress default l2acl 1-4ipv4acl 1-4ipv6acl, L2acl, Ipv4acl 1, Ipv6acl

cam-acl-egress

Allocate space for IPv6 egress ACLs.

S6000

Syntax

Parameters

Command Modes

Command History

Usage Information

Example

cam-acl-egress {default l2acl 1-4ipv4acl 1-4ipv6acl 0-4}

default	Use the default CAM profile settings, and set the CAM as
	follows:
	• L2 ACL(l2acl): 1
	• L3 ACL (ipv4acl: 1
	• IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4	Allocate space to support IPv6 ACLs. Enter all of the profiles
ipv4acl 1- 4	and a range. Enter the CAM profile name then the amount to
ipv6acl 0-4	be allotted. The total space allocated must equal 4. The
	ipv6acl range must be a factor of 2.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.4.2.0Introduced on the E-Series TeraScale.

8.2.1.0Introduced on the S-Series.

7.8.1.0Introduced on the C-Series.

For the new settings to take effect, save the new CAM settings to the startup- config (write-memor copy run start), then reload the system.

The total amount of space allowed is 4 FP Blocks.

Dell#

Dell#configure

Dell(conf)#cam-acl-egress ?

default Reset Egress CAM ACL entries to default setting

IPv6 Access Control Lists (IPv6 ACLs) 837