Dell 9.7(0.0) manual Vlan-stack trunk, Stack trunk command

vlan-stack trunk — specifies a Layer 2 port or port channel as a trunk port to the Stackable VLAN network.

vlan-stack trunk

Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network.

Syntax	vlan-stack trunk
	To remove a trunk port designation from the selected interface, use the no vlan-
	stack trunk command.

Defaults

Command Modes

Command History

Usage Information

Not configured.

INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on the E-Series ExaScale. C-Series and S-Series accept both bytes of the 2-byte S-Tag TPID.

7.8.1.0Functionality augmented for C-Series and S-Series to enable multi-purpose use of the port.

7.7.1.0Functionality augmented for E-Series to enable multi- purpose use of the port.

7.6.1.0Introduced on the C-Series and S-Series.

E-Series original

Command

Prior to using this command, to place the interface in Layer 2 mode, execute the switchport command.

To remove the trunk port designation, first remove the port (using the no member interface command) from all stackable VLAN-enabled VLANs.

1604 VLAN Stacking