Dell 9.7(0.0) manual Bgp dmzlink-bw, Bgp enforce-first-as, Dmzlink-bw

bgp dmzlink-bw

Enables BGP Link Bandwidth.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

Usage Information

bgp dmzlink-bw

To disable BGP Link Bandwidth, enter the no bgp dmzlink-bwcommand.

dmzlink-bw	Enter the keyword dmzlink-bwto enable BGP Link
	Bandwidth in BGP multipath.
N/A
ROUTER BGP

VersionDescription

9.7(0.0) Introduced on the S-Series.

Configuring or un-configuring the command will bring down and bring up the BGP Route Manager, this will result in tear down and re-establishment of all active sessions.

Link Bandwidth has to be configured on the router in order to tell it to associate Link Bandwidth with prefixes (paths) and/or to use Link Bandwidth in BGP Multipath route selection.

This is done under BGP configuration and is supported per address family – for IPv4 and IPv6 address families.

The configuration for a particular address family will apply across all VRFs configured.

This command must be performed on the router which is attaching link bandwidth to prefixes (typically a border router) as well as the router which is expected to load share traffic proportional to the bandwidth of the external links.

bgp enforce-first-as

Disable (or enable) enforce-first-as check for updates received from EBGP peers.

S6000

Syntax	bgp enforce-first-as
	To turn off the default, use the no bgp enforce-first-ascommand.

Border Gateway Protocol 353