Dell 9.7(0.0) manual Group

shutdown — disables/enables the port channel.

group

Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).

S6000

Syntaxgroup group_number port-channel number port-channel number

Parameters

Defaults

Command Modes

Command History

Related Commands

To remove an existing LAG supergroup, use the no group group_number command.

group_number Enter an integer from 1 to 32 that uniquely identifies this LAG fate-sharing group.

port-channelEnter the keywords port-channelthen an existing LAG

numbernumber. Enter this keyword/variable combination twice, identifying the two paired LAGs.

none

PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the C-Series, E-Series, and S-Series.

port-channelfailover-group — accesses PORT-CHANNELFAILOVER-GROUP mode to configure a LAG failover group.

show interfaces port-channel — displays information on configured Port Channel groups.

Interfaces 731