Dell 9.7(0.0) manual Debug dcbx, Defaults Ieee-v2.5

Parameters

auto cee cin Enter the DCBX version type used on the interface, where:

Defaults

ieee-v2.5

Auto

• auto: configures the port to operate using the DCBX version received from a peer.

• cee: configures the port to use CDD (Intel 1.01).

• cin: configures the port to use Cisco-Intel-Nuova (DCBX 1.0).

• ieee-v2: configures the port to use IEEE 802.1az (Draft 2.5).

Command Modes

Command History

Usage Information

INTERFACE PROTOCOL LLDP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.16.0Introduced on the MXL 10/40GbE Switch IO Module.

DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.

Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX configuration on a port, use the show interface dcbx detail command.

debug dcbx

Enable DCBX debugging.

Syntaxdebug dcbx {all auto-detect-timer config-exchng fail mgmt resource sem tlv}

To disable DCBX debugging, use the no debug dcbx command.

494 Data Center Bridging (DCB)